Advance Adapters 50-8410 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 50-8410
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 2 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-01-03
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
ASSEMBLY PROCEDURES:
1. The output shaft provided by Advance Adapters
should be installed by a an experienced transmis-
sion technician.
2. Trial fit the adapter on the transmission. Check
to see that the casting seats flush to the transmis-
sion case.
3. Trial fit the transfer case to the adapter and
transmission. Check for spline engagement, and
shaft depth into the input coupler of the transfer
case.
4. If the transfer case does not mate flush against the
casting,
DO NOT DRAW IT TOGETHER WITH
THE FASTENERS, SEVERE DAMAGE WILL
OCCUR
. If this happens, please call Advance
Adapters at 1-800-350-2223.
5. Install the rubber o-ring on the transmission side of the adapter. A thin
bead of silicone should be applied as a sealant.
6. Thread the four 10mm-1.5 studs into the transmission and push the
adapter over the studs until it seats completely into the transmission.
Thread on the 10mm-1.5 nuts and tighten.
GM 700R-4 AUTOMATIC TO BORG-WARNER
1350 & 1354 TRANSFER CASE