Advance Adapters 50-8100 - Manual (Page 3)

FORD C4 3 SPEED AUTOMATIC TO
JEEP DANA 300 TRANSFER CASES
ADVANCE ADAPTERS INC. P/N: 50-8100
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711081
Paso Robles, CA 93447 PAGE 3 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 12-04-08
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
CAUTION:
The shaft in this kit protrudes from the back side of the
adapter housing. If your original Jeep transmission
shaft was shorter, the new shaft may require shortening.
If you fail to make the necessary shaft adjustment, a
pre-loaded bearing condition will exist causing severe
damage to both the transmission and transfer case.
The modifications are not required on AX15 transmis-
sion replacements. All other applications may need
modifications.
When installing an Atlas
4 speed to this adapter,
the output shaft must be
trimmed. The output shaft
must be flush with the
rear of the adapter