Advance Adapters 50-7500 User Manual
Advance Adapters For the car
KIT CONSISTS OF:
No.
Qty
Part No.
Description
ADVANCE ADAPTERS INC.
P/N: 50-7500
P.O. Box 247, 4320 Aerotech Center Way
Old Part No: 711075
Paso Robles, CA 93447
PAGE 1 OF 3
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
08-07-08
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
FORD T18 4-SPD TRANSMISSION TO
JEEP DANA 300 TRANSFER CASE
1.
1
51-7500
ADAPTER CASTING (Ref: 711175)
2.
1
52-7503
T18 MAIN SHAFT (Ref: 711375)
3.
1 Pack 714202
BOLT PACK (50-7500)
4.
1
716452
SNAP RING (Jeep #8132631)
5.
1
716512
GASKET (NP435)(T18)
6.
1
716517
GASKET (Dana 300)
7.
1
716722
SEAL (NAT #472319)
8.
1
JP001
JEEP INSTRUCTION MANUAL
Before assembly of the transmission with the new
main shaft, you must verify that the correct shaft is
being used. Your spline count on the shaft must be
23-splines, Advance Adapters also manufactures a
27-splines shaft that will not be compatible with your
Dana 300 transfer case.
The T18 shafts had two main shaft
designs. The difference between the
shafts is the hub between the sec-
ond and third gears (both designs are
interchangeable into the transmis-
sion). Some shafts have a snap ring
and washer and others have the
spacer as part of the shaft. Most of
our shafts have the hub as part of
the main shaft. If you have the snap
ring design, just omit the washer and
snap ring when loading the gears on
the new main shaft.