Advance Adapters 50-7401 - Manual

ADVANCE ADAPTERS INC. P/N: 50-7401
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711074-19
Paso Robles, CA 93447 PAGE 1 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-16-13
KIT CONSISTS OF:
No.
Qty Part No. Description
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.
TURBO 350 TO TOYOTA LAND CRUISER
AUGUST 1980-89 (19 SPLINE)
1. 1 51-8900 CASTING (with sensor drilled) (Ref: 711189)
2. 1 52-8300 SHAFT (19 Splines)
3. 1 715547 TRANSFER CASE SHIFTER BRKT.
4. 3 715548 TRANSFER CASE BRKT. SPACERS
5. 1 716062 TH350 BUSHING
6. 1 *716079 SENSOR PLUG
(INSTALLED BY A.A.)
7. 1 716142 BUSHING/GEAR LOCATER
8. 1 716310 SEALED BEARING
9. 1 716321 SPECIAL SNAP RING FOR 716310 BEARING
10. 1 716511 "O"-RING
11. 1 716571 GASKET
12. 1 716758 TRANSFER CASE FRONT INPUT SEAL
13. 3 720062 12mm-1.25 x 90mm LONG H.H.C.S. (transfer case to adapter housing bolts)
14. 4 720063 12mm-1.25 x 40mm LONG H.H.C.S. (transfer case to adapter housing bolts)
15. 1 *720090 12mm-1.25 SET SCREW
(INSTALLED BY A.A.)
16. 3 723734 3/8"-16 x 2-1/2" S.H.C.S.
17. 7 724302 FLAT WASHER
18. 1 728703 26mm - 1.5 SHAFT NUT
19. 1 TLC001 LAND CRUISER INSTRUCTION MANUAL
SPECIAL NOTE: You may be required to change out the snap ring on the 308 bearing. The split-style
transfer case used two different diameter snap ring groves in the case. We have included both snap rings
to fit both styles of transfer cases.
Vehicles that were originally equipped with a manual transmission used a sleeve that locates the gear for the
transmission rear bearing and provides a seal surface. These applications do not require the use of our spacer
P/N 716142. You must retain this stock gear spacer on these applications. All other vehicles that have the seal
Note: this kit requires a
2WD output shaft that
must be shortended
If your transfer case was coupled to a manual transmission, Toyota used a single lip seal in the front of the transfer case.
We recommend changing the seal with a double lip seal that was used on the stock automatic applications.
Toyota # 90316-48003