Advance Adapters 50-7201 - Manual (Page 2)

FORD T18 4SP TRANSMISSION TO LARGE
HOLE JEEP DANA 18 (THIN ADAPTER)
ADVANCE ADAPTERS INC. P/N: 50-7201
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711072-T86
Paso Robles, CA 93447 PAGE 2 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-26-07
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
Some transmissions may require a modification to the cluster pin / reverse idler pin retaining bar. There are several different
styles of this bar and a few will interfere with the mounting of our adapter plate to the transmission. Before final assembly,
check the adapter plate for clearance and modify the retaining bar if necessary.
When using this adapter, you will be required to plug the oiling hole shown above. Use the 3/8" soft plug that has been
included with the kit. Apply a small amount of RTV blue silicone around the circumference of the plug. Using a punch,
slowly tap the plug into the hole until it is counter sunk just below the surface.