Advance Adapters 50-6905 User Manual
Kit consists of
ADVANCE ADAPTERS INC.
P/N: 50-6905
P.O. Box 247, 4320 Aerotech Center Way
New Item: (3/93)
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
05-09-05
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
KIT CONSISTS OF:
No.
Qty
Part No.
Description
1.
1
51-6400
ADAPTER CASTING (Ref: 711164)
2.
1
51-6901
ADAPTER CASTING (Ref: 711169-400)
3.
1
51-7700
ADAPTER CASTING (Ref: 711177)
4.
1
52-1300
SPUD SHAFT (Ref: 711313)
5.
1
716001
BEARING RETAINER WITH SNAP RING
6.
1
716302
BEARING
7.
1
716510
GASKET
8.
1
716511
O-RING
9.
1
716517
GASKET
10.
1
716568
GASKET
11.
1
716700
SEAL
12.
4
720046
METRIC S.H.C.S.
13.
5
723721
H.H.C.S. 3/8"-16 x 1"
14.
6
723722
H.H.C.S. 3/8"-16 x 1-1/4"
15.
1
728701
NYLON LOCK NUT 7/8"-16
GENERAL INFORMATION:
1.
The complete adapter assembly is approximately 29-1/2" long and is limited to long wheel base Jeep truck type vehicles.
The output shaft of the 700R-4 is a 2WD design that sticks out approximately 8" from the back of the main case. The
shaft must be shortened to a 5" stickout length for proper engagement into the Advance Adapters coupler. The angle
on the front driveshaft is very critical due to the clearance around the 700R-4 transmission pan.
NOTE: This kit requires the 2WD output shaft to be shortened. If you are using this kit on a newer hex bolt pattern
4L60E transmission, then you will be required to use our 51-0405 adapter housing. Please note that the cut off
location on the output shaft must be made after this adapter is installed on the transmission. This 51-0405 adapter
make the hex pattern 4L60E transmission look just like the square bolt pattern transmission, and the cut off location
for the output shaft is shown on this instruction sheet is for the square bolt pattern transmission.
GM 700R-4 TO DANA 20 6 SPLINE
TRANSFER CASE