Advance Adapters 50-3205 User Manual
Advance Adapters For the car
KIT CONSISTS OF:
No.
Qty
Part No.
Description
ADVANCE ADAPTERS INC.
P/N: 50-3205
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 3
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
12-12-13
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
1.
1
51-3205
ADAPTER HOUSING (#711164 Modified)
2.
1
716044
32T NP205 INPUT GEAR
3.
1
716315
NEW BEARING
4.
1
716458
SNAP RING
5.
1
716517
TRANSFER CASE GASKET
6.
6
723701
HEX NUTS 3/8"-16
7.
6
723704
3/8" LOCK WASHERS
8.
6
723711
STUD BOLTS 3/8"-16 X 2" LONG
GM 2WD 4L80E AUTOMATIC TO
FORD NP205 TRANSFER CASE
NOTE:
This adapter kit is for a stock 2WD 4L80E output shaft being adapted to a Ford NP205 transfer case. The output shaft
of the 4L80E has a 32 tooth spline so we are changing the input gear of the transfer case to the Advance Adapter Part
No. 716038. This new gear is directly interchangeable with the original Ford gear that only has 31 tooth internal spline.
The bearing and seal of the original Ford application will remain the same. You should make sure that the seal in your
transfer case matches the new input gear seal area. The adapter housing has been modified for clearance of the
transfer case shift controls. You will need to fabricate a new transfer case pivot support for the handle of the transfer
case. Most installations will require drive line modifications.