Advance Adapters 50-2704E - Manual (Page 3)

AODE/4R70E FOR BRONCO DANA 20
TRANSFER CASE 1966-76
ADVANCE ADAPTERS INC. P/N: 50-2704E
P.O. Box 247, 4320 Aerotech Center Way New Item: (3/93)
Paso Robles, CA 93447 PAGE 3 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-09-12
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend
that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
NOTES:
In order to mount the new adapter housing into the original
Bronco crossmember, you will need to modify the crossmember
for additional clearance. The new adapter housing is wider and
will require a slight elongation on the bushing index holes of
the crossmember.
In order to provide the clearance around the bottom part of the
adapter, we would suggest that you section a small portion of
the crossmember as shown in the illustration. This small portion
can then be relocated and rewelded as illustrated.