Advance Adapters 50-2700 - Manual

ADVANCE ADAPTERS INC. P/N: 50-2700
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711027
Paso Robles, CA 93447 PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-25-04
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
KIT CONSISTS OF:
No.
Qty Part No. Description
NEW PROCESS 435 & T18 4 SPEED TO
BRONCO DANA 20 1966-77
1. 1 51-1400 CASTING (Ref: 711114)
2. 1 716223 ALIGNMENT RETAINER
3. 1 716455 SNAP RING
4. 1 716512 GASKET
5. 1 716513 GASKET
6. 1 716713 SEAL (C/R #18676)
7. 1 716714 "O" RING SEAL
8. 2 723701 3/8-16 NUTS
9. 2 723704 3/8 LOCK WASHER
10 2 723711 3/8-16 X 2" STUD
11. 2 725004 HEX NUT 1/2"-13 NAT
12. 4 725016 S.H.C.S. 1/2"- 13 x 1-1/2"
13. 2 725040 1/2"-13 x 2.00 STUD
NOTE:
The T18 and NP435 2WD output shafts
may need the threaded portion of the
shaft cut off to prevent bottoming out
in the stock spud shaft.