Advance Adapters 50-1400 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-1400
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711014
Paso Robles, CA 93447 PAGE 1 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-06-14
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that
a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
OPTIONAL ITEMS:
Qty Part No. Description
1 716003 CROSSMEMBER
1 716302 SEALED BEARING
1 716001 (T86) LARGE HOLE OR
1 716002 (T90) SMALL HOLE
BEARING RETAINER
NOTE: Two TH400 bolt patterns have been drilled
into this housing; one is for a GM TH400 and the
other is rotated for the AMC TH400.
1. 1 51-0600 ADAPTER CASTING (Ref: 711106)
2. 1 52-1300 SPUD SHAFT (6-Splines)(Ref: 711313)
3. 1 *52-1401 29TH x 6SPL. 2.46: INPUT GEAR
4. 1 52-3200 OUTPUT SHAFT (Ref: 711332)
5. 1 716308 BEARING (#6209)
6. 1 716450 SNAP RING (GM #378-5205)
7. 1 716510 GASKET (GM #862-4709)
8. 1 716568 GASKET
9. 1 716707 SEAL (NAT. #472144)
10. 6 723701 HEX NUT
11. 11 723704 3/8" LOCKWASHER
12. 6 723711 3/8"-16 x 2" STUD BOLTS
13. 5 723723 3/8"-16 x 1-1/2" H.H.C.S. (T/C BOLTS)
14. 1 728701 NYLON LOCK NUT
*20 Degree pressure angle gear:
Model 18 transfer cases with 2.46:1,
w/ T14 transmission, 1 ¼” intermediate shaft
CJ with Buck V6 (68-71)
Drive gear# 18-8-50 (947382) ---29 tooth x 10 spline
Intermediate Gear # 18-5-9 (809293) ---39 tooth x 18 tooth
**Requires AA part # 52-1401
18-8-23 (809297) ----29 tooth x 6 spline (SUPPLIED IN KIT)
17 Degree pressure angle gear:
Model 18 transfer cases with 2.03:1,
w/ T14 transmission, 1 ¼” intermediate shaft
Jeepster/CJ (67-74) models 18/20
Drive gear# 18-8-49 (947339) ---26thx10sp.
Intermediate Gear# 18-5-16(946786) 34thx20th
(Special order gear)
TURBO 400 TO JEEP VEHICLES
DANA 18/20 TRANSFER CASE