Advance Adapters 50-0410 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-0410
P.O. Box 247, 4320 Aerotech Center Way New Item: (5/98)
Paso Robles, CA 93447 PAGE 1 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-10-12
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
1. 1 51-0410 ADAPTER (INDEX DIAMETER 4.8")
2. 1 716044 NP205 INPUT GEAR w/ 32T INTERNAL SPLINES
3. 1 716315 BEARING (for 716044 input gear)
4. 1 716458 SNAP RING (for 716044 input gear)
5. 1 716511 "O" RING (GM #135-8899)
6. 1 716572 NP205 GASKET
7. 1 716754 NATIONAL SEAL (#4435) (Installed by AA)
8. 6 720028 10mm 1.5 x 35mm LONG (May need to be shortened)
GM 4L80E AUTOMATIC TO
NP205 TRANSFER CASE 1971-79
NOTE:
THIS KIT TAKES A SPECIAL 2WD OUTPUT SHAFT (FULL SPLINE). PLEASE REFER TO THE O.E.M.
PART NUMBERS ON PAGE 2 BEFORE ORDERING OR OBTAINING YOUR TRANSMISSION.