Advance Adapters 50-0408A - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-0408A
P.O. Box 247, 4320 Aerotech Center New Item:
Paso Robles, CA 93447 PAGE 1 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-16-13
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that
a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
1. 1 51-8900 CASTING (with sensor drilled) (Ref: 711189)
2. 1 51-0405 4L60E / UNIVERSAL ADAPTER
3. 1 52-8300 SPUD SHAFT WITH 19 SPLINES (Ref: 711383)
4. 1 300619 SENSOR
5. 1 715547 TRANSFER CASE SHIFTER BRKT.
6. 3 715548 TRANSFER CASE BRKT. SPACERS
7. 2 716079 22mm PLUG
8. 1 716142 BUSHING/GEAR LOCATER
9. 1 716310 SEALED BEARING
10. 1 716321 SPECIAL SNAP RING FOR 716310 BEARING
11. 1 716511 "O"-RING
12. 1 716571 GASKET
13. 1 716758 TRANSFER CASE FRONT INPUT SEAL
14. 4 720028 S.H.C.S. 10mm-1.5 x 35mm
15. 3 720062 12mm-1.25 x 90mm LONG H.H.C.S. (transfer case to adapter housing bolts)
16. 4 720063 12mm-1.25 x 40mm LONG H.H.C.S. (transfer case to adapter housing bolts)
17. 1 *720090 12mm-1.25 SET SCREW (INSTALLED BY AA)
18. 3 723734 3/8"-16 x 2-1/2" S.H.C.S.
19. 7 724302 FLAT WASHER
20. 1 728703 26mm - 1.5 SHAFT NUT
21. 1 TLC001 LAND CRUISER INSTRUCTION MANUAL
GM 4L60E HEX AUTOMATIC OVERDRIVE
TO LAND CRUISERS 1980-89 FJ60 (4 SPEED)
NOTE: THIS KIT USES A 2WD 4L60E OUTPUT SHAFT (O.A.L. 18-3/16").
If your transfer case was coupled to a manual transmission, Toyota used a single lip seal in the front of the transfer case.
We recommend changing the seal with a double lip seal that was used on the stock automatic applications.
Toyota # 90316-48003
SPECIAL NOTE: You may be required to change out the snap ring on the 308 bearing. The split-style
transfer case used two different diameter snap ring groves in the case. We have included both snap
rings to fit both styles of transfer cases.