Advance Adapters 50-0407A - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-0407A
P.O. Box 247, 4320 Aerotech Center Way New Item: (03/99)
Paso Robles, CA 93447 PAGE 1 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-12-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that
a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
1. 1 51-8900 CASTING (with sensor drilled) (Ref: 51-8900)
2. 1 51-0405 4L60E ADAPTER
3. 1 52-1600 SPUD SHAFT WITH 16 SPLINES
4. 1 300619 SENSOR
5. 1 715547 TRANSFER CASE SHIFTER BRKT.
6. 2 716079 22MM PLUG
7. 1 716301 BEARING
8 1 *716345 BEARING SLEEVE FOR CASTING (INSTALLED BY AA)
9. 1 716507 GASKET
10. 1 716511 "O"-RING
11. 3 723731 3/8"-16 x 1" S.H.C.S
12. 4 720028 S.H.C.S. 10mm-1.5 x 35mm
13. 2 720063 12mm-1.25 x 40mm H.H.C.S.
14. 5 720085 12mm LOCK WASHER
15. 3 720089 12mm-1.25 x 130mm H.H.C.S.
16. 1 728701 NYLON LOCK NUT 7/8"-16
17. 1 728702 7/8" FLATWASHER
18. 1 TLC001 LAND CRUISER INSTRUCTION MANUAL
GM 4L60E HEX AUTOMATIC OVERDRIVE
TO LAND CRUISERS 1974-80 FJ40 (4 SPEED)
NOTE: THIS KIT USES A 2WD 4L60E OUTPUT SHAFT (O.A.L. 18-3/16").
NOTE: This kit requires the 2WD output shaft to be shortened. Please note that the cut off location on the output
shaft must be made after the 51-0405 adapter is installed on the transmission. This 51-0405 adapter make the
hex pattern 4L60E transmission look just like the square bolt pattern transmission, and the cut off location for
the output shaft is shown on this instruction sheet is for the square bolt pattern transmission.