Advance Adapters 50-0405E - Manual (Page 2)

GM 4L60E ADAPTERS WITH A 4L60E SHAFT
ADVANCE ADAPTERS, INC. P/N: 50-0405E
P. O. Box 247, 4320 Aerotech Center Way New Kit: (10/98)
Paso Robles, CA 93447 PAGE: 2 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 12-18-13
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific types of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand the modifications or changes that will be required to complete
your conversion, we strongly recommend that you contact our sales department for more information. This Instruction Sheet is only to be used for the assembly
of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque vales, wiring diagrams and
other related equipment. These manuals are normally available at automotive dealerships and parts stores.
You are now ready to bolt your conversion adapter to the 51-0405 kit. NOTE: On a few applications, customers
have not positioned the clamp in the incorrect position which has caused interference with the spud shaft
in the conversion adapter. If you try bolting the conversion adapter up to the 51-0405 and find
interference, the spud shaft may be hitting the clamp on the reluctor.
You will be required to do some modifications when
using this kit with a stock GM TH350 cast iron
adapter housing. The index hub on this casting
protrudes to far from the bolting surface. This hub
must be shortened approximately .625" to allow for
the proper fit of our adapter kit. The power sleeve will
also require shortening .250" on the transmission
side on this sleeve. Adapters that used a bearing
supported sleeve will be required to replace the
sleeve with our P/N 52-9503B
Warning Note:
Some adapter kits used in conjunction with this kit require an output shaft to be shortened. These kits
are typically retaining a stock 2WD transmission output shaft. The measurement given for the proper cut off length on these
adapter kits would normally be taken after the 50-0405 kit is installed onto your 4L60E transmission. Modifying a shaft without
compensating for the 50-0405 kit will require a new output shaft to be installed.
.010"-.012" Gap
P/N 300619
Sensor note: The sensor in this kit was changed in
October 2005. This sensor will match up with the GM pigtail
P/N 12162193 or Carquest P/N 57-4502 and NAPA, TSC200.
The old sensor used in earlier kits matches up to GM pigtail
P/N 12085498.