Advance Adapters 50-0225 User Manual
Kit consists of, Optional items

ADVANCE ADAPTERS INC.
P/N: 50-0225
P.O. Box 247, 4320 Aerotech Center Way
New Item: (09/97)
Paso Robles, CA 93447
PAGE 1 OF 3
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
08-13-14
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.
KIT CONSISTS OF:
No.
Qty
Part No.
Description
OPTIONAL ITEMS:
Qty
Part No.
Description
1.
1
51-0224
ADAPTER CASTING
2.
1
52-0225
10 SPLINE SPUD SHAFT (23T INTERNAL)
3.
1
716199
RETAINER
4.
1
716301
SEALED BEARING
5.
1
716507
GASKET
6.
8
720046
10mm-1.5 x 40mm S.H.C.S.
7.
2
723735
3/8" FLAT WASHER
8.
2
723739
3/8"-16 x 7/8" H.H.C.S.
9.
5
724303
7/16" LOCKWASHERS
10.
8
724324
7/16" HIGH COLLAR LOCK WASHER
11.
3
724345
7/16" x 14 x 5" HEX HD BOLT
12.
2
724349
7/16" x 14 x 1-1/2" H.H.C.S.
13.
1
728701
NYLON NUT
14.
1
728702
7/8" FLATWASHER
DODGE NV4500 5 SPEED23 SPLINE OUTPUT
TO TOYOTA L/C 10 SPLINE
NOTE:
This adapter kit has an overall transmission assembled length of 18.750". This kit was developed primarily for vehicles
that were retaining the original Toyota 6 cylinder engine. It could be used with a V8 installation without any difficulty.
CAUTION:
There are two 3/8" holes located on the side of the adapter for the mechanical shifter linkage. If your vehicle
has a 3 speed vacuum type shifter, these holes are not going to be used. They will need to be plugged with the
hardware provided and small amount of silicone. P/N715532 can be ordered if you have a mechical linkage.
1
715532
T/C LINKAGE
BRKT (For mechanical linkage)