beautypg.com

Advance Adapters 50-0213 User Manual

Kit consists of

background image

ADVANCE ADAPTERS INC.

P/N: 50-0213

P.O. Box 247, 4320 Aerotech Center Way

New Item: (08/94)

Paso Robles, CA 93447

PAGE 1 OF 3

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

7-14-14

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components

will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.

KIT CONSISTS OF:

No.

Qty

Part No.

Description

1.

1

51-0224

ADAPTER CASTING 6.375" LONG

2.

1

52-0213A

16 SPLINE SPUD SHAFT (31T INTERNAL)

3.

1 Kit

715532

TRANSFER CASE LINKAGE BRKT. ASSY.

4.

1

716199

BEARING SLEEVE FOR 716301 BEARING

5.

1

716301

SEALED BEARING

6.

1

716462

SET COLLAR

7.

1

716507

GASKET

8.

8

720046

S.H.C.S. 10mm 1.5 THR x 40mm

9.

2

723735

3/8" FLAT WASHER

10.

2

723739

3/8"-16 x 7/8" H.H.C.S.

11.

5

724303

7/16" LOCKWASHERS

12.

8

724324

7/16" LOCKWASHERS, HIGH COLLAR

13.

3

724345

7/16"-14 x 5" HEX HEAD BOLT

14.

2

724349

7/16"-14 x 1-1/2" H.H.C.S.

15.

1

728701

NYLON NUT

16.

1

728702

7/8" FLATWASHER

NEW VENTURE MODEL 4500 5 SPEED

TO TOYOTA L/C 16 SPLINE (Short Design)

NOTE:

This adapter kit has an overall transmission assembled length of 18.750". This transmission kit must be used with a 4WD
GM transmission.

CAUTION:

There are two 3/8" holes located on the side of the adapter for the mechanical shifter linkage. If your vehicle
has a 3 speed vacuum type shifter, these holes are not going to be used. They will need to be plugged with the
hardware provided and small amount of silicone.