Advance Adapters 50-0100 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-0100
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711001
Paso Robles, CA 93447 PAGE 1 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 05-14-14
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete
your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly
of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams
and other related equipment. These manuals are normally available at automotive dealerships and parts stores.
OPTIONAL ITEMS:
Qty Part No. Description
MUNCIE 4-SPD TRANSMISSION TO
JEEP & SCOUT DANA 18/20
1 715501 MOUNTING PLATE
1 716003 CROSSMEMBER
1 715625(6) LINKAGE
1 715600 HURST SHIFTER
1 716001 (T86) OR
1 716002 (T90) BEARING RET.
1 1 51-6000 ADAPTER- MUNCIE TO D300
2 1 51-7700 ADAPTER- D18/20
3 1 52-6100 SHAFT- MUNCIE 4SP TO D300 23T
**SHAFT NEED TO BE SHORTEND .500" BEFORE SHIPPING**
4
1 52-8600 SHAFT- JEEP T5 TO D18/20 23T
5 1 716500 GASKET SET-MUNCIE
6 1 716568 T.C. GASKET/JEEP&TOY L/C
7 1 716517 GASKET
8 1 716700 SEAL
9 1 716702 SEAL-MUNCIE
10 3 723701 NUT 3/8"-16 PLATED GRD 5
11 6 723704 LOCK WASHER
12 3 723710 STUD BOLT 3/8"-16 X 2-3/4"
13 3 723725 H.H.C.S. 3/8"-16 X 2" PLATE GR 5
14 1 724310 H.H.C.S. 7/16"-14 X 3"
15 1 728701 NUT-NYLON LOCK 7/8"-16
Installation notes:
This is a updated version of our Muncie Adapter kit. For 40 plus years we have been making a special 6 spline male shaft just for
the early Jeeps. This new kit uses a spud shaft that simplifies our inventory and manufacturing on this product line.
The new kit uses a casting and adapter plate, three of the mounting bolts on the plate to the casting are stud bolts with limited
clearance. You will need to install the studs into the adapter plate and assemble the lock washers and nuts to the studs as the casting
is being installed.
The output shaft in this kit has been shortened to avoid the spud shaft from bottoming out, once the main shaft is installed and
the spud shaft is installed into the adapter plate verify that the plate and casting mate without shaft interference. Some additional
grinding is sometime required on the mainshaft.