Advance Adapters 712585 User Manual
Page 3

ADVANCE ADAPTERS INC.
P/N: 712585
P.O. Box 247, 4320 Aerotech Center Way
New Item: (7/96)
Paso Robles, CA 93447
PAGE 3 OF 3
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
03-16-00
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
The clutch spline on the lower input shaft is 1/4" to 3/8" shorter than the
upper shaft. The splines should be 2-3/4" long to have the proper fit.
NV4500 TRANS. TO CUMMINS DIESEL
REPLACING GETRAG 5 SPEED (2WD)
Recommended Torque Ratings:
Clutch Pressure Plate
5/16" Bolts-17 ft./lbs.
Clutch Pressure Plate
3/8" Bolts-30 ft./lbs.
NOTE:
On some 1997 & newer transmissions,
we have found that some of the input
shafts were not splined as far as they
should be. This presents a problem
with regards to the clutch hub bottom-
ing out on the input shaft. If you are
having a problem or feel you may have
one of these transmissions with the
short clutch spline, we offer a new
shaft, Part No. 52-0228; or you could
purchase an earlier input shaft from
your Chrysler dealership. Refer to the
photo on below.