Advance Adapters 712584 - Manual (Page 2)

NV4500 TRANS. TO CUMMINS DIESEL
REPLACING GETRAG 5 SPEED (4WD)
ADVANCE ADAPTERS INC. P/N: 712584
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 2 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 01-06-00
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
Recommended Torque Ratings:
Clutch Pressure Plate 5/16" Bolts-17 ft/lbs
Clutch Pressure Plate 3/8" Bolts-30 ft/lbs
NOTE:
On some 1997 & newer transmissions
we have found that some of the input
shafts were not splined as far as they
should be. This presents a problem in
regards to the clutch hub bottoming
out on the input shaft. If you are
having a problem or feel you may have
one of these transmissions with the
short clutch spline, we offer a new
shaft, Part No. 52-0228, or you could
purchase an earlier input shaft from
your Chrysler dealership. Refer to
Photo #3 on page 3.