Advance Adapters 712582 User Manual
Advance Adapters For the car
ADVANCE ADAPTERS INC.
P/N: 712582
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
04-24-01
KIT CONSISTS OF:
No.
Qty
Part No.
Description
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
1.
1
712582-BLK
BELLHOUSING
2.
1
716170
PILOT BEARING (
.590"
)
3.
1
716176
GM THROW OUT LEVER
4.
1
716180
BALL PIVOT (
Installed
)
5.
1
716338
CLUTCH RELEASE ARM BOOT
6.
6
723730
S.H.C.S. 3/8"-16 x 1-1/4" LONG
7.
1
JP001
JEEP INSTRUCTION MANUAL
BUICK BELLHOUSING FOR 5.125" INDEX
GM STOCK TRANSMISSIONS
INSTALLATION INSTRUCTIONS:
This bellhousing is basically a copy of the early Buick manual transmission design. The index diameter is for the
larger truck-type transmissions. These transmissions would be the GM SM465 or the NP435. The ball pivot installed
in the bellhousing is compatible with the GM forged steel design release arm. A slave cylinder can be adapted if
necessary, but custom fabrication for the bracket will be necessary for proper positioning. We would recommend
the use of a Land Cruiser design, A/A #716119.
DUST COVER INSTALLATION
Currently we do not have a dust cover for this application and you will need to use one from a Buick application and
will need to modify it accordingly. If your engine is 1986 or newer and used the large rear main seal, you will need
to modify the inside diameter of the steel sheet metal plate to allow for clearance around the rear main seal area.