Advance Adapters 712572-A - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 712572-A
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 2 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-05-11
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
4 S P A C E R S B E T W E E N F L E X P L A T E &
TORQUE CONVERTER. 3/4"' O.D. X 5/16" I.D.
X .900" LONG--PART NO. 716172-FS.
(4) 5/16"-24 X 1.250" LONG
H.H.B.
MAKE SURE CONVERTER
DOES NOT BOTTOM OUT
I N C R A N K S U P P O R T
BUSHING
CHEVY ENGINE CRANK
CRANK BUSHING
PART NO. 712572-CB
(MODIFIED #716131-CB)
FLYWHEEL FLEXPLATE
PART NO. 712572-IB (168) INT BAL
ADAPTER PLATE
PART NO. 712572-PLT
CONVERTER BUSHING WILL PROVIDE THE
NECESSARY ALIGNMENT FOR BOLTING
CONVERTER TO FLEXPLATE
TORQUE CONVERTER MUST BE
INTERNATIONAL SCOUT.
I N T E R N A T I O N A L
SCOUT
T O R Q U E F L I T E
TRANSMISSION
SEE DETAIL
NOTE:
INTERNATIONAL
SCOUT BELL-
HOUSING MUST
HAVE HOLES
ELONGATED SO
BOLTS GO
DIRECTLY TO GM
ENGINE BLOCK.
SCOUT TORQUEFLITE TO
GM ENGINE UP TO 1985 ADAPTER KIT
CAUTION:
New flexplate is not equally
spaced and will only fit torque
converter in one position.
Do not force bolts into con-
verter. Check bolt pattern
alignment before assembly.