Advance Adapters 712571 - Manual (Page 5)

(2) HOLES TO BE ELONGATED
AS SHOWN
LOWER SECTION OF TWO PIECE DUST COVER
TYPE 2
TYPE 1
THERE ARE VARIOUS TYPES OF DUST
COVERS FOR THE JEEP MOTORS. WHEN
YOU HAVE FOUND OR ALREADY HAVE
THE PROPER DUST COVER, YOU WILL
NEED TO MODIFY IT ACCORDINGLY. CUT
OUT THIS AREA FOR SLAVE CYLINDER
CLEARANCE BEFORE ASSEMBLING THE
BELLHOUSING TO THE MOTOR. FAILURE
TO DO SO, WILL RESULT IN DISASSEMBLY
OF BELLHOUSING TO MOTOR.
ADVANCE ADAPTERS INC. P/N: 712571
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 5 OF 6
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-16-94
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
*NOTE: THE LOWER DUST COVER MUST BE
MODIFIED ACCORDINGLY BEFORE INSTALLATION
OF SLAVE CYLINDER. SLAVE CYLINDER SHOULD
BE INSTALLED TO TOP OF DUST COVER.
BELLHSG. FOR JEEP 4.0 & V8 304 ENG.
TO NV4500 & GM SM465 TRUCK 4 SPEEDS