Advance Adapters 712564 User Manual
Page 2

ADVANCE ADAPTERS INC.
P/N: 712564
P.O. Box 247, 4320 Aerotech Center Way
New Item: (08/06)
Paso Robles, CA 93447
PAGE 2 OF 3
Telephone: (800) 350-2223
Fax: (805) 238-4201
REV DATE:
04-19-10
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
AX15 5 SPEED TRANSMISSION RETRO-FIT
FOR THE AX5 4 CYL. 5 SPEED HYD. SLAVE
specifications.
3.
Install the new clutch disc and pressure plate onto the flywheel
4.
Install the two new dowel pins into the adapter plate. The pins are a press fit.
5.
With the AX15 transmission on a work bench, remove the front bearing retainer.
Clean the surface of any silicone.
6.
Apply a new thin film of silicon to the transmission face where the front retainer was
just removed. Install the new adapter plate to the transmission. This adapter aligns
to the front input bearing of the AX15 transmission. We have
provided two clearance pockets on the adapter plate for the old
AX15 dowel pins. Install the six 10mm bolts and the two 8mm
bolts to retain the adapter plate.
7.
Install the new seal into the new retainer snout. Then install
the retainer onto the adapter plate with silicone around the
outside edge to seal the retaier to the plate. Install the roll
pin for the internal release bearing.
8.
The stock 4 cylinder bellhousing should now be installed
onto the adapter plate. Make sure the new dowel pins in
the plate align to the bellhousing. Install the new release
hydralic bearing onto the retainer.
9.
Most rebuilt AX15 transmissions do not come with a shift handle. If yours did then
skip this step. The AX5 shifter bolts to the transmission with four bolts and this is
a different bolt pattern than that of the AX15 transmission. Since a new shift handle
is hard to come by, we have opted to make the AX5 shifter work with the AX15
transmission. The shift body bolt holes are approximately a 1/2" of a hole off from
bolting on to the AX15 transmission. So remove the stick from the aluminum shift
housing and elongate the four holes to line up with the AX15 transmission hole, using
712563-S as a template. Once the holes line up with the AX15, you will also be
required to modify the oil splash sheet metal piece. The new modified shifter can
then be installed onto the AX15 transmission. Silicone should be applied on each
surface. The 712563-S goes on first, the sheet metal oil shield second, and the
aluminum housing last. Note the last two pieces are installed backward compared