Advance Adapters 712541 - Manual (Page 2)

BRONCO II & RANGER 5 SPEED TRANS TO
FORD V8 BELLHOUSING 1965 & UP
CLUTCH REQUIREMENTS:
#384070 11" DODGE DISC 1"-23 SPLINE
#N1714 CLUTCH RELEASE BEARING
11" PRESSURE PLATE:
#CF260000 11" PRESSURE PLATE WITH 5/16" BOLTS
#CF360049 11" PRESSURE PLATE WITH 3/8" BOLTS
CRANK
6-1/2"
1/2"
BEARING
6-1/4"
3/4"
BELLHOUSING
ADAPTER
STOCK SEAL KEEPS TRANSMISSION FLUID IN
TRANSMISSION. CUT ALUMINUM RETAINER OFF.
USE HACKWAW & BE CAREFUL NOT TO DAMAGE
SEAL WHEN REMOVING.
THIS SURFACE INDEXES
INTO ADVANCE ADAPTER
PLATE
STOCK
TRANSMISSION
8-1/2" STOCK
2.5" STOCK
NEW BOLTS & LOCKWASHERS
TO HOLD ADAPTER PLATE TO
FORD BELLHOUSING
NEW RETAINER TO PILOT
INTO FORD (4.848")
BELLHOUSING
( 4) METRIC BOLTS WITH LOCK WASHERS FOR HOLDING UP
ADAPTER PLATE TO TRANSMISSION. MAKE SURE THEY FIT
FLUSH WITH ADAPTER PLATE.
SPECIAL NOTE
The transmission clutch disc plines
may need to be ground slightly for
pilot bearing clearance to prevent
bottoming out. SEE ILLUSTRATION.
ADVANCE ADAPTERS INC. P/N: 712541
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 2 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-21-96