Snorkel TB125J - Manual (Page 40)

Chapter 7 – Prestart Inspection
40 T125J/TB125J – 0192214
The outlet is equipped with a ground fault circuit inter-
rupter (GFCI). Use the following procedure to test the
GFCI.
1. Push the test button (refer to Figure 7.31).
2. Plug an electrical tool into the outlet and verify the
power is off.
If the power is off, push the reset button to
restore power.
If the power is on, repair or replace the recep-
tacle.
Figure 7.31 – Electrical Power Outlet
Drive Motion Alarm
The machine may be equipped with an optional drive
motion alarm. Drive in both the forward and reverse
directions to ensure that the alarm sounds to warn per-
sonnel in the area that the aerial platform is in motion.
Driving and Work Lights
The machine may be equipped with driving lights and/or
platform work lights. Turn the engine on and use the
switch on the back of each light to momentarily turn it
on to see that it works.


Platform Control Cover
The machine may be equipped with an optional platform
control cover. Inspect the cover to ensure it fits properly
over the control panel.
Tow Kit
The machine may be equipped with an optional tow kit.
Inspect the tow bar and steering arm to verify the com-
ponents are present and in working condition.
Placards and Decals
Inspect all safety and operational placards and decals.
Make certain they are in place, in good condition and
are legible.
The placards and decals may be cleaned with soap and
water, and a soft cloth if the words or pictures cannot
be seen.
Caution
Solvents may contain hazardous ingredients. Fol-
low the manufacturer’s label for proper use and
disposal. Wear protective gloves and splash-proof
safety glasses when using solvents.
Wet paint overspray may be removed using a natural
biodegradable solvent and a soft cloth.
Replace any missing or illegible placards or decals
before operating the aerial platform. Placard and decal
kits are available from Snorkel.
The safety related placards and decals are illustrated
on the following pages.
Electrical
Power Outlet