beautypg.com

Snorkel TB125J User Manual

Page 18

background image

Chapter 4 – Safety Devices

18

T125J/TB125J – 0192214

Ground Operation Switch

The ground operation switch (refer to Figure 4.1) pre-

vents boom and platform movement if a control switch

on the lower control panel is accidentally moved.

Hold the switch up to operate the machine from the

lower controls.

Platform Foot Switch

Stepping down on the platform foot switch (refer to

Figure 4.6) activates the upper controls.

Figure 4.6 – Platform

The foot switch must be engaged and a control must be

moved to operate the boom, drive and/or platform from

the upper controls.

Guardrails

The guardrail system includes a top rail, mid rail and

toeboards around the sides of the platform (refer to

Figure 4.6).

A gravity gate (refer to Figure 4.6) or an optional swing-

ing gate allows for access to the platform.

The gates close automatically after entering or exiting

the platform. The gate is part of the guardrail system and

must be securely fastened after entering the platform.

Lanyard Anchors

Two lanyard anchors for fall restraint anchorage are

provided below the upper controls at the front of the

platform (refer to Figure 4.6).

Note

The lanyard anchors are not for lifting or tying the ma-

chine down.

All personnel in the platform must connect their fall

restraint device to a lanyard anchor before raising the

platform. Do not use the aerial platform for personal fall

arrest anchorage.

Figure 4.4 – Right Side of Upper Controls

Emergency Lowering Knob

The emergency lowering knob may be used to lower

the booms if the engine will not start and the emergency

power system and bleed down system will not work.

The knob is located at the base end of the main boom

lift cylinder, under the center of the turntable (refer to

Figure 4.5). It is accessible from the underside of the

turntable.

Figure 4.5 – Emergency Lowering Knob

The knob may be turned to open the cylinder bleed down

valve for emergency lowering.

Axle/Boom Interlock

The rear axles on the chassis extend to help stabilize

the machine when the boom is raised or extended.

The axle/boom interlock prevents the boom from extend-

ing and from raising above horizontal if the rear axles

are not properly extended and locked in position.

Emergency

Lowering Knob

Toeboard

Top Rail

Mid Rail

Gravity

Gate

Lanyard

Anchors

Platform Foot

Switch

Emergency Bleed

Down Switch

This manual is related to the following products: