Snorkel POP UP EC08 - Manual (Page 17)

Periodical maintenance and checks
(continued)
Prior to first use of the Pop-Up+, all daily/pre-use checks must be undertaken.
If the machine has been in storage for a long period of time, it may be necessary
to undertake additional checks and tests as per the table on the preceding page
(e.g. lubrication, hydraulic oil, battery condition).
The Lifting Operations and Lifting Equipment Regulations 1998 (LOLER) require
that lifting equipment for lifting persons must be THOROUGHLY EXAMINED
every six months.
Following any maintenance on the
Pop-Up+, a full function test should be
undertaken to ensure correct operation of the machine.
It is essential that only manufacturer’s approved replacement parts are used
when maintaining and servicing the Pop-Up+. Failure to do so may result in an
unsafe or unstable machine.
Storage
The electrical components of this Pop-Up+ are not protected from external
weather conditions and the machine should therefore not be stored outdoors.
Storage in a clean, dry indoor environment is recommended.
Frequent checks on the condition of the machine should be made to ensure
no excessive deterioration occurs due to the environment in which the
machine is housed.
Lubrication
The required lubrication points are shown opposite.
Lubrication points are to be found on the end of the scissor pack
at both ends of the machine.
The lubricant recommended for use with this
Pop-Up+
Pop-Up+
is:
standard machine grease
Section 5
MAINTENANCE
Page 16 of 25 Operator’s Safety and Maintenance Handbook (dual use machine rev.0.0.1.0210)
0120723