Snorkel MHP15J - Manual (Page 59)

11. Options
■ Air Line To Platform
This con sists of *” pres sure flex yel low hose rated
at 150 psi work ing pres sure, fit ted with quick dis -
con nect cou plers at each end .
■ Dual Fuel
This op tion con sists of an AC mo tor rated at ei ther
110 or 230 volts AC 50/60Hz. A se lec tor switch is
used to change from gas o line to elec tric. The same
con trols are used to stop and start the elec tric mo tor.
This op tion is used in shop ping malls and other
built up ar eas.
■ Work Lights
Rub ber en cased work lights can be fit ted to the
plat form guard rails. The lights are swivel mounted
and each has its own switch.
■ Flashing Light
● For this option see Chapter 2 page 3
■ RCD/ELCB AC Outlet
A 3 core wire rated at 600 volts AC 15 amps is run
up the booms as stan dard.
● For this option see Chapter 2 Page 3.
■ Sandblast Protection Kit
This op tion con sists of a bel lows type cover fit ted to
each boom cyl in der shaft.
The bel lows pre vent sand and paint from dam ag ing
the cyl in der rods and seals, and thus pre vent hy -
drau lic oil leaks.
DO NOT paint or sandblast from an MHP15J
unless the cylinder rods are protected by
bellows.
■ Platform Rotator
This op tion al lows the op er a tor to move the plat -
form around the boom, 45
o each side of cen ter, to
gain better ac cess to work sites.
■ Self Levelling Stabiliser
This op tion con sists of a mi cro pro ces sor that con -
trols the sta bi lis ers. The sta bi lis ers will ‘self level’
the plat form when the auto mode is se lected, al ter -
na tively the sta bi lis ers can be used in
di vid u ally
when in the man ual mode.
MHP15J – 11995A page 11 - 1
CAUTION