Platform control switches 7-6, Ac outlet rcd/elcb (option) 7-6, Placards and decals 7-6 – Snorkel EPV16J User Manual
Page 40: Standard placards and decals 7-6, Ac outlet rcd/elcb, 7-6, Placards and decals, 7-6, Standard placards and decals, 7-6, Standard placards and decals -6, Caution, Chapter 7. pre-operational inspection

■ Platform Control Switches
Figure 7.22 - Platform Control Switches
On the ground con trol box set the Ground/Plat -
form Se lec tor to plat form.
Check that each of the platform moving switches
( through to ) cause the platform to move the
way it should.
Check both po si tions of each switch.
For cor rect op er at ing pro ce dures see the ”Op er a -
tion” chap ter 8.
NOTE
Pay particular attention to the Emergency Stop
switch to see that it turns the EPV16J engine
off when struck.
Pay particular attention to the platform foot switch
to see that it deactivates the platform moving
switches when the foot switch is not stepped on.
■ AC Outlet RCD/ELCB (option)
Figure 7.23 - AC Outlet RCD/ELCB
If the EPV16J has this op tion fit ted check the RCD
works by con nect ing a power source to the base in -
let and an ap pli ance to the plat form out let.
Push the test but ton on the RCD/ELCB de vice and
the power out let at the plat form should not work.
RCD/ELCB devices should only be replaced
by a qualified electrician.
■ Placards and Decals
Look to see that all plac ards and de cals are in place
and leg i ble. Re place any miss ing or il leg i ble plac -
ards or de cals be fore plac ing the EPV16J into ser -
vice for the daily work shift.
De cal and plac ard kits for the EPV16J are avail able
from Snor kel deal ers.
❑
Standard placards and decals
See page 7 - 7 for the fol low ing items.
page 7 - 6
EPV16J – 11089A
Chapter 7. Pre-operational Inspection
CAUTION
No
Part No
Description
Req
1
0112471
Decal - Snorkel
2
2
9207
Decal - Hydraulic oil
1
3
0070420
Decal - Emergency lower
2
4
11226-25
Decal - EPV16J
2
5
007-1925
Decal - Gasoline
1
6
300699
Decal - Operator checklist
1
7
0323897
Decal - Danger
1
8
11420
Decal - Lower control box
1
9
0323899
Decal - Electrocution hazard
1
10
112249
Decal - Stabiliser control
1
11
11420-1
Decal - Upper controls
1
12
2025-200
Decal - Safe working load
1
13
99228
Decal - Caution
1
14
1772-002K
Decal - Boom lock pin
2
15
9428
Decal - Danger (Australia Only)
1
1843
Decal - Warning (NZ Only)
1
16
0150448
Decal - Harness point
1