Snorkel XRT33-sn2300+ANSI - Manual (Page 4)

Page 4 XRT Work Platform
Figure 3: Platform Controls
26. PLATFORM CONTROLS, Turn Plat-
form Controls Key Switch clockwise
to ON.
NOTE: If the engine is cold;
Dual Fuel Models - Push and hold
the Choke Button while starting the
engine.
Diesel Models - Push and hold the
GLOW PLUG Button for 6 seconds
before starting engine to engage the
glow plugs.
27. Turn Platform Controls Key Switch
fully clockwise to start engine,
release the key once the engine
starts.
28. Turn Lift/Drive Switch to DRIVE.
NOTE: The Speed Range Selector
Switch has three positions; HIGH
SPEED, MID SPEED, and HIGH
TORQUE. Perform Step 29 for each
speed.
29. Engage the Interlock Switch and
move the Control Handle FORWARD,
then REVERSE, to check for speed
control.
30. Push the Steering Switch RIGHT,
then LEFT, to check for steering con-
trol.
31. Turn the Lift/Drive Switch to LIFT.
32. Engage the Interlock Switch, and
push the Control Handle forward to
check platform lift controls. Raise the
platform to full elevation.
33. Pull back on the Control Handle. The
platform should descend and the
Audible Lowering Alarm should
sound.
34. Lower the platform completely.
35. Push the Platform Emergency Stop Switch to check for proper operation. All the machine func-
tions should be disabled. Pull out the Platform Emergency Stop Switch to resume.
36. Turn Platform Controls key switch to OFF.
37. Push Chassis Emergency Stop Switch to the OFF position.
38. Push Platform Emergency Stop Switch to the OFF position.
Speed Range
Selector Switch
Interlock
Switch
Key Start
Switch
Dual Fuel:
CHOKE
Diesel:
GLOW PLUG
Proportional
Control
Handle
EMERGENCY
STOP
Speed Range
Selector Switch
LIFT/
DRIVE
Switch
Steering
Rocker
Switch