Snorkel XRT33-sn2300+ANSI - Manual (Page 3)

Page 3 XRT Work Platform
Figure 1: Chassis Controls
15. Turn Platform Controls Key
Switch clockwise to ON.
16. CHASSIS CONTROLS,
Turn the Platform/Chassis
Switch to CHASSIS.
NOTE: If the engine is cold;
Dual Fuel Models - Push
and hold the CHOKE
Button while starting the
engine.
Diesel Models - Push and
hold the PREHEAT Button
for 6 seconds before
starting engine to engage
the glow plugs.
17. Push and hold the START
Button to start the engine.
Release the Button once
the engine starts.
18. Push the THROTTLE But-
ton in, and push the RAISE
button to fully elevate the
platform.
19. Visually inspect the elevating assembly, lift cylinder, cables and hoses for cracked welds,
loose hardware, hydraulic leaks, loose wire connections and erratic operation. Check for
missing or loose parts.
20. Partially lower the platform by pushing in on the Chassis Controls LOWER button, and check
operation of the audible lowering alarm.
Figure 2: Emergency Lowering Knob
21. Pull out on the Emergency Lowering
Knob to check for proper operation.
Once the platform has lowered com-
pletely, release the knob.
22. Push the Chassis Emergency Stop
Switch to check for proper operation. All
the machine functions should be dis-
abled. Pull out the Emergency Stop
Switch to resume.
23. Turn the Platform/Chassis Switch to
PLATFORM.
24. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and
debris), is level, and capable of supporting the wheel loads.
25. Mount the platform and properly close the entrance.
EMERGENCY
STOP
START
Dual Fuel: CHOKE
Diesel: PRE-HEAT
THROTTLE STOP
Platform/
Chassis
Selector
Switch
RAISE
LOWER
Dual Fuel:
Fuel Selector
Diesel:
Plug
EMERGENCY
LOWERING KNOB