Snorkel X33BE-sn10131+V-1 - Manual (Page 36)

7. Daily Inspection and Maintenance
At the start of each work day (or 8 hour shift), an RT
qual i fied op er a tor must per form the Daily In spec -
tion and main te nance (or Pre-Op er a tion In spec tion
as it is some times re ferred to), as listed in the ta ble
be low.
The pur pose of the Daily In spec tion and Main te -
nance is to keep the
RT in proper work ing con di tion
and to de tect signs of mal func tion at the ear li est
pos si ble time.
Set the Key Switch to OFF be fore you be gin this in -
spec tion.
De fec tive parts and/or equip ment mal func tions
jeop ar dize the safety of the op er a tor and other per -
son nel, and can cause dam age to the ma chine.
DO NOT operate an
RT that is known to be
damaged or malfunctioning.
R e p a i r a l l e q u i p m e n t d a m a g e o r
malfunctions, before placing the
RT into
service
SR3370 & SR2770 – 13184A Rev A page 7 - 1
Item Service Required
Fuel level Visually inspect
Fuel filter (diesel engines only) Visually inspect (condition)
Fuel leaks Visually inspect (hoses and connections etc)
Engine oil Check oil level (between dipstick lines)
Engine coolant Check fluid level and radiator hoses
Radiator cap Visually inspect installation)
Swinging gate Visually inspect (installation, operation)
Wiring harnesses and connectors Visually inspect (installation, operation)
Battery terminals Visually inspect (no corrosion)
Battery fluid level Visually inspect (covers plates)
Hydraulic tank cap Visually inspect installation)
Hydraulic oil level Check fluid level (at line on side of tank)
Hydraulic oil leaks Visually inspect (hoses,tubes)
Tires and wheels Visually inspect (condition)
Bolts and fasteners Visually inspect (looseness)
Structural damage and welds Visually inspect (welds, cracks, dents)
Guardrails Visually inspect (condition)
Lanyard anchorages (option) Visually inspect (condition)
Bubble level on platform Visually inspect (condition)
Guides, rollers and slides Visually inspect (condition)
Non slip tread grip Visually inspect (condition)
Wrist support Visually inspect (condition)
Operator manual Visually inspect (that the manual is in the holder)
Placards, decals, and Operators Manual Visually inspect (installation and condition)
START THE ENGINE FROM THE GROUND CONTROL BOX
Charging system Check condition (gauge)
Ground controls Actuate and visually inspect for operation
Emergency lowering Check operation (causes correct motion)
Platform controls Actuate and visually inspect for operation
Flashing light Visually check (operation)
RCD / ELCB (option) Check operation
Air filter Check condition
Safety prop Check operation
Parking brakes Check operation
■ Daily Inspection and Maintenance Table
DANGER