Snorkel X Series-sn15020-17279 - Manual (Page 9)

9 X-Series Work Platform
F OLD D OWN GUARDRAILS , X32N
This procedure applies only to the X32N model for the purpose of passing through a standard double doorway.
Guardrails must be returned to proper position before using the machine.
F OLD D OWN P ROCEDURE
1. Unhook the controller from the side guardrail and place it on the platform.
2. Pull the retaining pin on the front guardrail and rotate inwards.
3. Pull the retaining pin on the rear guardrail and rotate inwards.
4. Starting with the slide-out deck guardrails and then the outer guardrails, lift up on each guardrail and fold
inward.
E RECTION P ROCEDURE
1. Starting with the outer guardrails and then the slide-out deck guardrails, raise each guardrail and drop it
down, securing it in the vertical position.
2. Rotate the front and rear upper guardrails outward and secure them to the opposite side guardrails, using
the retaining pins.
3. Hang the controller on the side guardrail.
A FTER U SE E ACH D AY
1. Ensure that the platform is fully lowered.
2. Park the machine on a firm, level surface, preferably under cover, secure against vandals, children, and
unauthorized operation.
3. Turn the Key Switch to OFF and remove the key to prevent unauthorized operation.
This machine is not insulated. Follow your national safety standards and maintain the
required safety distance when working near energized equipment.
W A R N I N G ! !
Before operating the machine, guardrails must be securely fastened in their
proper position.
THIS MACHINE IS
NOT INSULATED
Electrocution Hazard