Addictive Desert Designs 2010 - 2014 Ford Raptor Fender Inner - Manual (Page 2)

3. Measure and Cut away pinch welds at the rear of the wheels. Start at 6.75" down from mount,
see picture below right, and cut down to the end of the curve in the body. Clean up any burrs
and coat to protect the bare surfaces.
4. Fit the Inner into place by using the Front Outer Frame Member (Right behind the front valance
which was cut in sequence #2) and the rear of the liner pushed into the pinch weld in the rear.
5. With the liner in place, mark and drill 1/8" holes from the bottom up through the liner into the
Frame Member avoiding factory holes.
Use 2 - Self tapping screws to attach the
front of the liner to the Front Frame
Outer Member.