Addictive Desert Designs 2014 - UP Chevy/GMC 1500 54 Radius Bar Roof Mount - Manual

Addictive Desert Designs
2014 - UP Chevy/GMC 1500
54”radius bar roof mount
installation instructions
PREPARATION STEPS
1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the
emergency brake set.
2. You will need the following tools:
a. Drill
b. 1/4” Drill Bit
c. 1/4” Rivets (6)
d. Tape Measure
Note: This installation requires 2 people for best results
3. Included in Kit:
a. Right Mount(1)
b. Left Mount(1)
INSTALLATION INSTRUCTIONS
1. Mount light bar into both Roof Mounts to create an assembly.
2. Carefully measure mount locations by measuring 22 3/16” from lower pillar at Fender to bottom
of mount at the location shown below. Do this for both sides of the truck.