Addictive Desert Designs 2009 - 2013 F-150/Raptor Race Series Front Bumper - Manual

Addictive Desert Designs
2010 – 2014 Ford Raptor
Race Series Front Bumper
Installation instructions
PREPARATION STEPS
1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the
emergency brake set.
2. You will need the following tools:
a. ½” drill bit
b. ¾” wrench
c. ¾” Socket
d. Ratchet
e. 15MM socket and ratchet
f. Sharpie type marking pen
g. Center punch
3. Hardware Included:
a. 8 – ½” x 1 ½” Bolts
b. 8 – ½” Nuts
c. 12 – ½” Flat washers
**2 – 15mm Skid plate Bolts will be re-used in the installation
INSTALLATION INSTRUCTIONS
1. Remove factory Front Bumper and front skid
plate (Keep the 2 – 15mm Skid plate Bolts for
re-use) .
2. Fit the Bumper onto the truck and use the
Sharpie to mark the frame horn to drill the
½” holes. The red arrows are the holes to be
drilled, the blue arrows show the factory
slots. Slots and holes will be opposite for the
Drivers side