Addictive Desert Designs 2010 - 2013 Ford Raptor Rear Frame Gusset/Bump Stop Kit - Manual

1. Disconnect the negative terminal on the
battery. With the vehicle on level ground
and the emergency brake set, block the
front tires.
2. Jack up the rear of the vehicle and
support the frame rails with jack stands.
Never work under an unsupported
vehicle!
3. Remove the rear tires.
4. Remove the spare tire.
5. You do not need to remove the bed for
this installation, but it will make the
installation much easier.
6. You will need the following tools:
a. 90’ drill
b. ½” drill bit
c. ¾” wrench
d. ¾” – ½” drive socket and ratchet or impact gun
e. 13MM socket and ratchet
f. 1-1/4 wrench (for the top bolt on the bump stop)
7. Hardware Included:
a. 6 – 4 ½” x ½” Grade 8 Bolts
b. 4 – 4” x ½” grade 8 Bolts
c. 6 – 1 ½” x ½” Grade 8 Bolts
d. 32 - ½” Grade 8 Washers
e. 16 – ½” Locknuts
f. 4 – 3/16” x 2” x 2” x ½” OD Square Washers
1. Remove factory stock bump stop and mount from the frame.