Installation instructions, Seat adapter bracket kit – Smittybilt 49903 Seat Adapter Bracket Kit User Manual
Page 3
WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Seat Adapter Bracket Kit
03-06 Wrangler (Part # 49902) Driver Side
03-06 Wrangler (Part # 49903) Pass. Side
(Fig E)
Step 10: Place seat on frame, lining up the holes/slots on the brackets on the bottom of the seat with the
threaded rods. Secure with the included washers and nut. (Fig F)
Step 11: Re-install the seat belt bracket you previously removed using the OEM hardware. (Fig G)
Step 12: Install seat back in vehicle and secure with the previously removed hardware. Make sure all
hardware is secure. Installation is now complete.
Re-route the other cable with the white end
from the right mounting location to the left
Instead of a spacer use
the seat belt bracket on
the rear inside
On the rear outer rod,
you will place a
spacer, the one nylon
ring then the tilt lever
and the second
nylon
ring.
(Passenger side
only)
NOTE: With some aftermarket seats you may be required to cut/trim
the rear wings off of the OEM brackets