Installation instructions, Seat adapter bracket kit – Smittybilt 49903 Seat Adapter Bracket Kit User Manual
Page 2
WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Seat Adapter Bracket Kit
03-06 Wrangler (Part # 49902) Driver Side
03-06 Wrangler (Part # 49903) Pass. Side
(Fig A)
(Fig B)
(Fig C)
(Fig D)
Note: If you are not using the factory seat belt, and instead some kind of harness, you can replace the seat
belt bracket with another round spacer.
Always wear/use your seat belt.
Re-route the other cable with the white end from
the right mounting location to the left (pictured)
Install the four 8mm threaded studs into the factory
seat riser. (The short end of the stud goes into the riser)
Install spacers over the threaded rods.
On the rear outer rod, you will place a spacer, the one
nylon ring then the tilt lever and the second
nylon ring.
Connect tilt cable to end hole in lever.