beautypg.com

Smittybilt 17191 6 Fender Flares User Manual

Page 2

background image
















Forward

Vertical Seam

Cut line tangent to
Wheel Arch Opening

Fig E

Fig F

Align flares with

Factory Hole

Cut lines tangent to
Wheel Arch opening

Factory hole

Trimming Vehicle Fenders – For YJ ONLY with 33” or Larger Tires

1. Measure 4-3/4” from the back vertical seam of the front fender towards front of

vehicle and mark this location at the bottom edge of the fender. (See: Fig E)

2. From this measurement draw a straight line up tangent to the radius of the

vehicle fender opening. Cut away metal using an air nibbler or other suitable
tool. Coat this area with a rust inhibitor to prevent rusting. (See: Fig E) Proceed
to rear fender. (See: Fig F).

3. Draw a line tangent to the radius of the rear wheel arch, through the factory

screw mounting hole and repeat this procedure for the front of the wheel arch.
Cut away the metal using an air nibbler or other suitable tool. Coat this area with
a rust inhibitor to prevent rusting. Repeat for all remaining fender wells.

Align flare with
vertical seam

Installation Instructions
6” Fender Flares (#17191)

1987-1995 Jeep Wranglers