Synergy 8554 - 94-02 Dodge Truck Track-Bar Conversion Bracket - Manual (Page 8)

10) At this time, check to make sure the ½-13 UNC x 5” long bolt will fit through the bracket and cross
member. Also take note on if the ¼” shim spacer provided in the kit will be needed for your application
or not.
o Some models have a slot in this position, while others have a hole that is often not aligned with
the hole on the cross member. See reference pictures below.
o If your truck has a hole and not a slot, try to fit the ½” bolt through the frame, if it does not fit,
then drill out hole using a 9/16” drill bit or using a dremel / die grinder, clearance the hole so the
bolt will go all the way through the cross-member.