Synergy 8091 - Jeep JK Front Track Bar Bracket (RHD) - Manual (Page 3)

4. Position the new PPM-8091 track bar bracket over the stock track bar bracket as
shown below. Secure the bracket to the sway bar tab using the supplied 1/2 x 3” bolt
and spacer. There are 3 cylindrical spacers included with this kit, use one of the
longer
1.5” (38mm) ones for this step. Use a washer under the head of the bolt and
under the toplock nut. Do not tighten any of the track bar bracket hardware until all
of the hardware is installed.
5. Insert the shortest of the 3 spacers where the stock track bar bushing was. Install the
9/16 x 3” bolt in the track bar relocation bracket through the stock track bar mounting
hole. Use a flat washer under the bolt head and under the lock nut.