Synergy 8091 - Jeep JK Front Track Bar Bracket (RHD) - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8091 JK FRONT TRACK BAR RELOCATION
BRACKET, RIGHT HAND DRIVE
Version 2
GENERAL NOTES:
• On Rubicon models the installation of this bracket requires some minor grinding
on the diff housing, no other cutting or drilling is required.
• This bracket should be used with the PPM-8001 drag link flip kit.
• You must use a minimum of 3” of front bump stop extension, PPM-8057 (3”) and
PPM-8075 (4”) to prevent the track bar and bracket from hitting the bottom of the
frame at full jounce travel.
• If you have a Rubicon model or front Dana 44 and and ARB diff cover, you will
need to trim this track bar relocation bracket to fit.
1. Remove the factory front track bar from the axle bracket and loosen the track bar
from the frame bracket to allow the track bar to rotate out of the way. Secure the
track bar up and out of the way with a bungee cord or something similar. Also
remove the steering stabilizer.
2. Remove the factory anti-sway bar links from the axle brackets, or remove completely
if using new anti-sway bar links.
3. If you have and ARB diff cover and a Rubicon model with a Dana 44, trim 7/16
(10mm) front the end of the track bar relocation bracket.