Synergy 5102-0X - Jeep JK Louvered Hood Panel - Manual (Page 3)

4) Place the hood on a sturdy work surface that will allow you to easily access all 4
sides. A saw horse set, small cart or small table should work well. Be careful to
cover any possible marring surfaces with a towel or rags to prevent damage to the
hood’s finish.
5) Installation of the 5102 JK Hood Louver Panel can now begin.
Start by placing the panel on the hood, centering it over the holes
for the U-shaped tie down point. Also, center the windshield
nozzle in the cut out. This should get you in the ballpark.
Next square up the hood to both the front and rear edges using a
square or measuring tape. (See Picture 5.1 and 5.2 below)