Mountain Off Road JKST07 User Manual
Mountain Off Road For the car
MOUNTAIN OFF ROAD ENTERPRISES, LLC.
P.O. BOX 690 DELTA COLORADO 81416
(877)JEEP-A2Z or (877)533-7229
(888)698-5337 FAX
E-mail:
www.mountainoffroad.com
INSTALLATION INSTRUCTIONS
for
JKST07
Please read and understand all instructions before beginning the installation of the Hide-A-
Step. Please read the terms and policies on the back of these instructions.
This step mechanism uses a very strong spring. Extra care should be
used during installation and use to prevent injury to fingers and hands!
The JKST07 Dead Pedal is designed to fit the following Jeep® vehicles: 2007 to current JK
Wranglers. The step is designed to work along with the factory Rubicon rock rails. The step
may interfere with other factory installed or aftermarket steps or rocker guards. The step is de-
signed to be quick detachable by removing two pins.
STEP 1:
If your jeep has factory installed Rubicon rock rails, Remove the two nuts and
single bolt from the center rocker guard mount. (See figure 1) If your Jeep does not have
rocker guards proceed to step 1A.
STEP 2:
Pry Down on the rocker guard mounting arm and slide the step base (see fig-
ure 2) over the 2 studs. The step base plate goes between the body of the Jeep and the
rocker guard mounting arm. (See figures 3 and 3A)
STEP 4: Reinstall the 2 nuts onto the studs and install the button headed bolt with a fender
washer into the back hole.
STEP 5:
Line up the holes and insert the two removable pins to complete assembly.
(See figure 4)
STEP 6:
The step has raised dimples to provide traction but care should be taken dur-
ing use to prevent slippage. Mud, ice, and snow will make the step slicker. You are now
done so GO JEEPIN!
Page 1
HARDWARE KIT:
1– Step Assembly
1– M8x1.25x25mm Button Head bolt
1- M8 u-nut
1– 5/16 Fender washer
2– 1/4”x3/4” Bolts
2– 1/4” Top-loc nuts
4– 1/4” washers
2– 5/16” pins