Mountain Off Road 7686-6 - Manual

ITEM: DESCRIPTION: SIZE: QTY: PART #
A BRACKET-PIVOT DS 1 7686-DS
B BRACKET-PIVOT PS 1 7686-PS
C FRAME SPACER PLATE 3”X6-1/4”2 HOLES 4 7686-FS
D BOLT-BRACKET DS 7/16-14X1-1/2 2 15159
E BOLT-BRACKET PS 7/16-14X1-1/4 2 15157
F BOLT-BRACKET 5/8-11X2 2 15311
G NUT-BRACKET BOLT 5/8-11 4 37036
H BOLT-BRACKET 5/8-11X4 2 13319
I BOLT-SPRING 9/16-12X4-1/2 2 13271
J NUT-SPRING BOLT 9/16-12 2 37270
K TUBE-SPACER FRAME 7/8X1-7/8X.120 2 S107686
L WASHER-FLAT 7/16 SAE 4 33084
M WASHER-LOCK 7/16 SPLIT 4 33624
N WASHER-FLAT 9/16 SAE 4 33088
O WASHER-FLAT 5/8 SAE 8 33090
P BRACKET-BOLT ON SHACKLE HANGER 2 SR106
Q SLEEVE-BRACKET 3/4X1-9/16X.120 4 S101599
R BOLT-BRACKET 1/2-13X2-3/4 4 13214
S NUT-MISC. 1/2-13 4 13268
T WASHER-FLAT 1/2 SAE 8 33086
U BOLT-BRACKET 3/8-24x1 2 18834
V WASHER-FLAT 3/8 SAE 2 33028
W WASHER-LOCK 3/8 SPLIT 2 33622
- INSTRUCTION SHEET 1 7686-6IS
7686– 6 PAGE 1
INSTALLATION INSTRUCTIONS FOR M.O.R.E.™ SHACKLE REVERSAL SYSTEM
(S.R.S.™)
PART # 7686-6
THIS SYSTEM FITS 1976-1986 Jeep® CJ-5, CJ-7, CJ-8 VEHICLES.
Please read all instructions carefully (including terms-policies) before work is started on your vehi-
cle. Familiarize your self with all components in this system. These instructions will refer to all
items by letter not description. In addition to basic hand tools, the following specialty tools are
needed to perform this installation: Power drill with 1/2" chuck, angle head drill with 1/4" chuck
(electric or air), Oxy/Acetylene cutting torch, grinder, 3/4” diameter drill bit, 1/2” diameter drill
bit, 21/64 drill bit, 3/8-24 tap, floor jack, jack stands (4), torque wrench, 15/16” wrench & socket.
NOTES: SRS may not be compatible on Jeeps with Nerf Bars or any type of side bars that attach
to the frame at the point in which the shackles will be hung from.
Some aftermarket headers may cause interference with the SRS.
MOUNTAIN OFF ROAD ENTERPRISES
LLC.
P O BOX 690, DELTA, COLORADO 81416
970-625-0500
E-mail: [email protected]
S.R.S.™ # 7686-6 contains the following items: