beautypg.com

Mountain Off Road BLCJ8185 User Manual

Instructions for m.o.r.e

background image

Thank you for purchasing this M.O.R.E.

Body Lift Kit/System. It is designed to fit 1980-1986 Jeep CJ-5, CJ-

7,andCJ-8 vehicles with manual or automatic transmissions. It will work with or with out a suspension lift kit.
Read all instructions before starting the installation. Please call if you have any questions.

CONTENTS:
QUANTITY:

DESCRIPTION:

SIZE:

LOCATION: (see figure 1)

11*

Aluminum Puck

2-1/4" x I"

All.

8 *

Hex Head Bolt

3/8" x 3-1/2"

2,3,4,5,6.

3

Hex Head Bolt

7/16" x 3-1/2"

1. (and/or6)

2

Hex Head Bolt

3/8" x 4"

2,6.

8 *

Washer-Flat

3/8"

2,3,4,5,6.

3

Washer-Flat

7/16"

1.

Locations 6 may use 7/16" x 3-1/2" bolts. Check the diameter of your stock body bolts to determine which
replacement bolts are to be used for your application. *CJ-8 Scrambler kit will come with 2 extra pucks, bolts
and washers. Their location will be 5 and 6 in figure 1.











There are 4 steps to be addressed when installing this body lift kit on your Jeep

CJ:

1: The steering shaft and/or column.
2: The radiator/fan shroud.
3: The clutch linkage (or automatic transmission shift linkage).
4: Installing the one inch 0 pucks and longer bolts.

STEP 1: The steering shaft and/or column. Since the body is going to be raised from the frame by one inch

and the column is attached to the body, the shaft that connects the column to the steering box will have to
gain length by approx. 3/8". There are two ways to make this happen:
1A: The shaft is telescoping from the factory (so it can collapse in case of a collision). To make it gain length
or extend the two halves must have the plastic locking device removed. The plastic must be melted out by
heating the shafts. If you choose this method (A), remove the entire shaft from the Jeep

. Use a torch and

slightly heat the two halves until the plastic is melted out and the two shafts will slide apart. Do this in a well
ventilated area cause the meeting plastic stinks! Clean them with a wire brush, and paint them. Do not rein-
stall the steering shaft at this time. See figure 2.

BLCJ8086 & BLCJ8185

PAGE 1 of 4

MOUNTAIN OFF ROAD ENTERPRISES,

LLC.

P.O. BOX 690, DELTA, COLORADO 81416

970-625-0500

970-625-3747

Fax

E-mail: [email protected]

www.mountainoffroad.com

INSTRUCTIONS for M.O.R.E.

BLCJ8086 & BLCJ8185 1” BODY LIFT KIT

This manual is related to the following products: