Mountain Off Road BLYJ8795A - Manual

Quantity: Description: Size: Location:
11 Puck-Aluminum 2-1/4” x 1”
1/2” hole
All
5 Bolt 7/l6” x 3-1/2” 1,5,6
6 Bolt l/2” x 4-1/2” 2,3,4
2 Bolt 1/4” x 3/4” Trans. Linkage Bracket
2 Lock Nut 1/4” Trans. Linkage Bracket
1 Bracket Trans. Linkage Bracket
5 Washer-Flat 7/16” 1,5,6
6 Washer-Flat 1/2” 2,3,4,
MOUNTAIN OFF ROAD ENTERPRISES,
LLC.
P.O. BOX 690, DELTA, COLORADO 81416
970-625-0500
970-625-3747
Fax
E-mail: [email protected]
www.mountainoffroad.com
INSTRUCTIONS for M.O.R.E.
™
BLYJ8795A 1” BODY LIFT KIT / SYSTEM
This M.O.R.E.™ One Inch Body Lift Kit fits 1987-1995 Jeep® YJ® Wrangler®
vehicles with ether 2.5L or 4.0L engines, with Automatic transmissions, with or
without air conditioning. This kit has been designed to fit on YJ Wrangler’s that
are stock (no suspension lift), or Wrangler’s that have been lifted with aftermar-
ket suspension lift kits up to 4”. Please read all instructions and our Terms and
Policies on page 2 before you begin installing this kit. Familiarize yourself with
all components in this kit and the parts of your Jeep that you will be working on.
Common hand tools are required and some knowledge of mechanical things
are needed. This kit contains the following items:
Page 1 of 3
©
1. Remove the plastic front frame cover between the bumper and grille.
2. Remove the steel strip just in front of the grille that holds the steel brake line in place. Remove the two
plastic clamps that locate the brake line to the steel strip and save them for later.
3. Remove the 4 bolts holding the shroud to the radiator.
4. Loosen but DO NOT REMOVE all 11 body to frame mounting bolts. Hint : The two hidden bolts
are located behind the rear axle just in front of the fuel tank ( location 5 )
5. Remove the one bolt under the grille. Remove 5 bolts on the drivers side of the Jeep.
6. Place a stout piece of wood under the floor pan between body mounts 3 and the outside edge of the
body. Jack up the body on the piece of wood just enough to place the 1” pucks on top of the rubber insula-
tors. It is recommended that you use lock tight on the new longer bolts to keep them in place. Start the new
longer bolts into the body but DO NOT tighten them at this time. Repeat this procedure on the passenger
side of the body. Install one puck under the grille and start it’s longer bolt.