Mountain Off Road JRB900 - Manual (Page 3)

PAGE 3 of 6
14– You will need to press the wheel studs into the tire carrier, make sure to do this for the cor-
rect wheel pattern (5 on 4 1/2” or 5 on 5 1/2” ) (Figure 13&13A)
15- Insert tail light grommet into tire carrier plate. Press brake light into grommet. Wire pigtail
into the stock third brake light wiring harness and plug into brake light (see figure 14). Be sure to
leave enough slack in wires for the swinger to operate through a full range of motion.
10– When installing the spare tire you will want to slide the base so that when the tire is tight it is
pre loaded against the tube. ( Figure 15)
11- Install stainless steel logo into threaded holes with supplied screws.
12– The High-Lift jack mount will work with both the cast base style and stamped base style
jacks. There are holes in the lower base to add a lock or bolt . The jack will be retained in the top
mount as shown in ( Figure 16)
13– The locking pin should be lubricated ( anti-seize) periodically and make sure that you pull it
before you try to open or close the carrier !