Mountain Off Road JFBS100 - Manual (Page 2)

PAGE 2 of 2
M.O.R.E.™ recommends pre-fitting this BUMPER into your Jeep® BEFORE you paint it. Make
sure that you Have no fit issues with any Aftermarket accessories and that you are happy with all
aspects of it. If you are, then paint it and re-install it. Once you modify it in any way, it is NON-
RETURNABLE !!!
1– Remove Factory bumper , if equipped remove any lights.
2– Install winch into winch tray using supplied hardware with the winch. ( Depending on winch it
may be necessary to install the 2 -1/2” carriage bolts into the slotted holes in the winch tray on the
passenger side).
3– Install S107686 sleeves into large holes on the side of the frame. (See Figure 1) Attach Left &
Right brackets to the frame using the 5/8”-11x 2” & 5/8”-11x4” bolts ,flat washers and 5/8” crimp
Lock nuts. Do not tighten at this time. ( See figure 2)
4– Slide the bumper over the frame and align the slotted holes in the winch tray with the frame
brackets and the bottom holes on the bumper with the factory holes . Install 7/16”-14x 1 1/4”
bolts ,flat washers and Lock nuts into both lower holes. (There may be some clearance issues
with the bottom of the bumper at the frame with some aftermarket accessories). Install the 1/2”
Carriage bolts through the winch tray holes and into the frame brackets. Install 1/2” flat washers
and Crimp lock nuts to these bolts. Do Not tighten any bolts until all bolts have been installed.
(See figure 3)
5– Level bumper and tighten all bolts.
Figure 1, ( P.S. of Jeep) Figure 2
Figure 3